How to Replace a Ford1986 F150 Turn Signal Switch with Pictures

The Ford1986 F150 is a tough and rugged pickup truck that has been dependable for many drivers over the years. It is well known for its reliability and performance. The one area where these vehicles may have some hiccups is in the electrical system, especially when it comes to the turn signal switch. Replacing a Ford1986 F150 turn signal switch is not overly complicated and can be done with a few tools and basic knowledge of wiring diagrams. In this article, we will cover how to replace a Ford1986 F150 turn signal switch using easy-to-follow steps with pictures to help guide you.

Tools, Parts, and Wiring Diagrams

Before you begin to replace your Ford1986 F150 turn signal switch, you should gather the necessary tools, parts, and wiring diagrams. You will need a basic set of tools such as pliers, wire cutters, and a screwdriver. For parts, you will need a new turn signal switch and some electrical tape. Finally, you will need to obtain a wiring diagram for your Ford1986 F150 to ensure that you understand the connections.

Remove the Old Turn Signal Switch

Once you have the required tools, parts, and wiring diagram, you can start to remove the old turn signal switch. First, locate the switch on the steering column and then disconnect the electrical connector. Next, unscrew the retaining screws and remove the old switch from the steering column. Make sure to keep track of the screws and their locations so that you can easily reinstall the new switch.

Install the New Switch

Now, you can install the new turn signal switch. Begin by connecting the new switch to the electrical connector. Then, position the switch in the steering column and screw in the retaining screws. Make sure to use the correct screws in the right locations. When the switch is securely attached, you can move on to the wiring diagram.

Connecting the Wires

Using the wiring diagram, you can now connect the wires to the new switch. Start by locating the ground wire and then the power wire. Next, connect the appropriate wires to the correct terminals on the switch. Make sure to get the correct orientation and check for tight connections. When finished, wrap the connections with electrical tape to protect them from moisture and dirt.

Testing the Connections

The last step is to test the connections. Turn on the ignition and try out the turn signal switch. Make sure that the switch functions properly. If everything works correctly, you have successfully replaced the Ford1986 F150 turn signal switch.

By following these simple steps, you can replace a Ford1986 F150 turn signal switch quickly and easily. With the help of pictures and a wiring diagram, you can make sure that the new switch is correctly connected to the electrical system of your vehicle.

Ford F150 Turn Signal Switch Blinker Replacement Standard Motor Products Motorcraft Diy Solutions Dorman Api Brock Skp 2015 2016 2012 2013 2011 2014 2007 2018 15 16 12 13 11 14 07 18 Partsgeek Com